The machine simulator problem

[ayhan01]

The machine simulator problem
Hello. I made a simple application of a lift. However, the limit switch to stop the elevator does not stop. Could not figure out the problem. Files attached. Examine the files declare the problem would be very happy.


[attachment deleted by admin]

[EasyPLC_Master]

The problem was in the machine configuration, the elevator has two inputs one to detect the upper position and other to detect the lower.
Here is attached the machine corrected.


[attachment deleted by admin]

[ayhan01]

The problem was in the machine configuration, the elevator has two inputs one to detect the upper position and other to detect the lower.
Here is attached the machine corrected.

Thank you. works nicely