Virtual PLC on run mode, but not connected to machine.

[fredz0003]

I literally read the whole manual, and I can't seem to connect to the machine I am missing something?
The demo programs works fine as soon as I send and transfer program and power up virtualPLC the disconnected status on machine changes to stop mode. But in my own program I just can't seem to link from virtual plc to Machine, the ethernet light is yellow. Any help will be appreciated.

Fernando Balandran

[fredz0003]

Now I unmarked the box on simulatedDriver where it says enabled, and the ethernet is green and the status on the virtualPLC is connected but machine still says disconnected.

[fredz0003]

Now I checked the box on simulatedDriver where it says enabled, and the ethernet is green and the status on the virtualPLC is connected but machine still says disconnected. I am getting frustated I don't know what else to do I don't see any more settings.

[EasyPLC_Master]

Can you send me your program in order to see if is ok?.
Also some screenshots showing your problem will help.
Thanks.

[EasyPLC_Master]

Please once you solve the problems, will be useful for all users if you comment what was the operation done to make the system works!!!

[fredz0003]

I really don't know what was causing the problem, but I just made it a routine to save, compile, connect to plc, and run plc.

[fredz0003]

I figured out what's wrong with the software, when you create a new project the default I/O device doesn't connect at all with the machine, now I remembered what I did with my last project, I had to remove the default I/O device, add a new one and configure it, then it works like a charm, not sure why when a new project is created the I/O device doesn't work, perhaps a bug. Just wanted to let the creator how I made it work. 

[EasyPLC_Master]

This thread is solved in http://nirtec.com/forum/index.php?topic=261.0