Print Page - Performance and graphics settings.

Title: Performance and graphics settings.
Post by: cendre on April 15, 2026, 10:39:25 AM

Hi @ll

Issues with the graphics settings [MS v4.5.7]

Graphics set to very low and disabled all advantages.
After [apply changes] and check settings again, ... [attached image]

I hope that this is a problem and can be solved very quickly :/

Compared to a competing program (F-IO)...
I had no issues with performance or graphics, even with 300 assets :(

I have Intel UHD graphics and have to go into low settings.

Title: Re: Performance and graphics settings.
Post by: EasyPLC_Master on April 15, 2026, 01:56:15 PM

Hi!

First change all the needed parameters as explained in page 34 (Suggested configuration for equipment with low resources) of the C:\Nirtec\Machines Simulator 4\Help\Machines Simulator Instruction Guide.pdf, then press the
Apply changes button located in the bottom side.
Your new configuration must be applied.

Nirtec Studio Forum

General Category => General discussion => Topic started by: cendre on April 15, 2026, 10:39:25 AM