Print Page - cannot use analog in v 4

Title: cannot use analog in v 4
Post by: leom on January 17, 2025, 04:34:36 PM

i installed version 4 ms.
I am tying to program plc to run a machine Gantry .
Loader. I cannot access the analog inputs, analog outputs with the plc. I can insert manually but not with plc control. I had previously ran wheels machine in version 3.6 with no problem, but a cannot access the analog inputs and outs inversion 4. I have the exact same settings in both version, but in version 4 the set buttons always on

Title: Re: cannot use analog in v 4
Post by: EasyPLC_Master on January 17, 2025, 06:04:27 PM

We have tested in V4 and works well, please review your Modbus Server configuration.

Title: Re: cannot use analog in v 4
Post by: leom on January 30, 2025, 09:49:19 PM

I have the exact same settings for ver 3.6 and ver 4 but the data does not go into v 4 but it does in version 3,6

Title: Re: cannot use analog in v 4
Post by: EasyPLC_Master on January 31, 2025, 09:07:57 AM

Remember to use the Modbus Holding Registers memory area of your Server App.
Machines Simulator exchanges the Analog I/O using the Holding registers of Modbus memory area.

Nirtec Studio Forum

General Category => Machines Simulator => Troubleshooting => Topic started by: leom on January 17, 2025, 04:34:36 PM